Home › Home Remodeling Glossary › Architectural Shingles
Building and Exterior term
Architectural Shingles
Definition: Architectural shingles are asphalt roofing shingles made from two or more bonded layers, which gives the roof a thicker, dimensional look and more weight than single layer three tab shingles.
What is an architectural shingle?
Architectural shingles are asphalt shingles, so the code rules for any asphalt shingle roof apply to them. Carroll County has adopted the 2021 International Residential Code as amended by the Maryland Building Performance Standards, and its roofing chapter sets the basics.
Under that code, asphalt shingles must comply with ASTM D3462. They must also be tested for wind resistance under ASTM D7158, or ASTM D3161 for shingles outside that standard’s scope, with the required classification shown on the packaging label.
Why it matters
Architectural shingles are a common choice on roof replacements around Westminster today. Because Carroll County does not require a permit for re-roofing, no county inspector checks the installation, so the installer's training and attention to the manufacturer's specs carry the job. Certified Home Remodelers is a GAF Certified Roofer and Shingle Master.
Carroll County does not require a permit for re-roofing unless structural work is involved, but its permits office notes the installation still has to meet the current code for new installation and all manufacturer requirements. The code points below show what that means in practice.
Code basics for asphalt shingles
- Shingles must be fastened to a solidly sheathed deck.
- They may be used only on slopes of 2:12 or steeper, and slopes from 2:12 up to 4:12 need a double layer of underlayment.
- Nails must be galvanized steel, stainless steel, aluminum or copper roofing nails with at least a 12-gauge shank and a 3/8-inch head, long enough to go at least 3/4 inch into the sheathing, or through it if it is thinner.
- Each strip shingle needs the number of fasteners the manufacturer requires, and never fewer than four.
- A drip edge is required at eaves and rakes, with pieces overlapped at least 2 inches and fastened no more than 12 inches apart.
Tear-off or a second layer?
The code defines roof replacement as removing existing layers down to the deck. A new layer over an old one is not allowed when the existing roof is water soaked or too deteriorated to serve as a base, when it is slate, clay, cement or asbestos-cement tile, or when it already has two or more layers. Existing flashings, edgings, vents and similar parts must be replaced where they are rusted, damaged or deteriorated.
Questions to ask before you sign
- Will the old roof be torn off to the deck?
- Which underlayment and ice barrier will be used, and where?
- What wind classification is printed on the shingle packaging?
- Which flashings and drip edges will be replaced?
Learn more
These pages cover the paperwork side of a roofing project.
Related Certified Home Remodelers services
Frequently asked questions
Do I need a permit to replace my shingles in Carroll County?
Not unless structural work is involved. Carroll County says re-roofing does not require a permit, but the work must meet the current code for new installation and the manufacturer’s requirements.
Can new shingles go over my old roof?
Only in limited cases. The code does not allow a roof recover over a roof that is water soaked or deteriorated, over slate or tile, or over a roof that already has two or more layers.
How many nails does each shingle need?
The code requires the number the manufacturer specifies, but never fewer than four fasteners per strip shingle or two per individual shingle.
Sources
- Owens Corning: Roofing Shingles
- IKO: What are Architectural Shingles
- Carroll County Permits and Inspections: FAQs
Planning a project in Carroll County?
Ask about your remodel, addition, roof or siding project: Contact Certified Home Remodelers.
